Guide · Updated November 2026

PU Injection vs Waterproofing Membrane: Which Fix Does Your Leak Need?

PU injection seals cracks from inside; a membrane protects a whole surface. Compare when each works, cost basis and lifespan, with a quick decision table.

PU Injection vs Membrane: Side-by-Side Comparison

PU injection compared with a waterproofing membrane
QuestionPU injectionMembrane
What it doesSeals a crack from inside the concreteCovers the whole surface with a waterproof layer
Best forActive leaks through cracks and jointsRoofs, balconies and slabs leaking over a wide area
Works while leaking?Yes, resin reacts with waterNo, surface must be dry
Hacking needed?NoSometimes, to remove old layers or tiles
PricedPer point or metre of crackPer sq ft of area
Weak spotNew cracks can form elsewherePoor detailing at drains and edges

When PU Injection Is the Right Choice

Choose injection when water comes through a defined crack or joint in otherwise sound concrete: a car porch soffit, a basement wall, a ceiling crack under a slab or a construction joint. Injection works from below, so the floor or roof above does not have to be disturbed. See our PU injection service.

When a Waterproofing Membrane Is the Right Choice

Choose a membrane when the leak is spread out, when the surface is exposed to rain and sun, or when the old waterproofing has clearly failed. Flat roofs usually need torch-on membrane; balconies and terraces with many details suit PU elastomeric coating.

Quick Decision Checklist

  • One visible crack dripping, slab otherwise dry: injection.
  • Many wet patches across a ceiling under a roof: membrane.
  • Running water now, roof also old: injection first, then membrane.
  • Not sure: leak test first, then decide.

Frequently Asked Questions

Is PU injection cheaper than a membrane?

For a single crack, yes, because only that crack is treated. For a roof or slab that is leaking over a wide area, injecting crack after crack ends up costing more than a membrane, and still leaves the surface unprotected.

Can PU injection and a membrane be used together?

Yes. A common approach is to inject active cracks first to stop the running water, then lay a membrane on top to protect the whole surface.

Which lasts longer, injection or membrane?

They do different jobs. Injection is a long-lasting seal for that crack. A membrane protects the whole surface and, as a general guide, lasts around five to ten years depending on the system and exposure.

Want a Professional Opinion on Your Leak?

Send photos on WhatsApp. We will tell you what we think is happening and arrange a leak test.